Filters
Close

Super Collet Removal Tool

Use this solid collet plug to remove your super collet without damage. Simply remove the existing insert, and loosen the screw 2-3 turns. Put this removal plug in place, and tighten the collet with two wrenches as you normally would. The collet pops off every time! No damage to the collet or insert. No holding the flywheel! Reusable many times.
Availability: In stock
Manufacturer part number: ZIPP-CT
Manufacturer: Zipp Kits
$6.95
Write your own review
  • Only registered users can write reviews
*
*
  • Bad
  • Excellent
*
*
*
*
Customers who bought this item also bought

Crankshaft bearing shim

shim washer
$1.25

Threaded Coupler 4-40

This is a Threaded end for on 4-40 rod .
$2.25

Water Jacket Installation Tool - V2.

By using this tool , the water jacket is pressed down over the o-rings to properly seat the water jacket .This tool threads into the sparkplug hole / tighten the jam nut to push the jacket down . Next install the 3mm bolts and tighten accordingly . This will lessen the possibility of stripping the small bolt holes . We have been using this style of tool for years . Very handy . Comes with bolt / jam nut / 2 steel washers / 1 nylon washer and a protective sleeve for storage .
$12.95 $8.95

Driveshaft Alignment Tool

Alignment tool
$3.50

Shaft Saver

1/4" shaft saver
$6.00

Carburetor 90 Degree Inlet Fitting

Walbro carb fitting
$3.50