Filters
Close
RSS

New products

Ball Wrench Set, 5 Pc Metric

Features The perfect tools for getting at those hard to reach places Ball wrenches make it possible to turn socket head screws/bolts at any angle Set contains one each of: 1.5mm, 2.0mm, 2.5mm, 3.0mm, and 4.0mm Overview Key Features Ball wrenches make it possible to turn socket head screws/bolts at any angle Set contains one each of: 1.5mm, 2.0mm, 2.5mm, 3.0mm, and 4.0mm The perfect tools for getting at those hard to reach places Overview The perfect tools for getting at those hard to reach places. Ball wrenches make it possible to turn socket head screws or bolts from any angle. Set contains one each of : 1.5MM, 2.0MM, 2.5Mm, 3.0Mm, and 4.0MM.
$25.40 $20.95

Performance Worksheet

Down load our free worksheet . Take it to the lake and record all of your information from testing . Compare to other testing sessions to find your best setup . Keeps track of what props etc worked per setup . Great information to look over . PDF file. Read below for instructions.
$0.00

Flywheel Puller - Basic

Basic flywheel puller . Easy flywheel removal with this tool ! Bolts included .
$19.95

Flywheel Puller - V2

Version 2 flywheel puller . Handle & bolt equipped for easy use . Makes flywheel removal easy !
$32.95

Flywheel Setting Tool Set

Tools used to properly seat & tighten a flywheel . The lever shaped tool threads into the flywheel to be used as a hand held device to keep the flywheel from turning . The included flanged nut is threaded onto the shaft in order to seat the flywheel correctly on the crankshaft stub. After tightening the flanged nut to seat the flywheel , untighten & remove the flanged nut . Remove the flywheel holder . Install & tighten the correct starter pawl .
$21.95

Spring Tool

Tool for removing & installing springs on the hot pipe setup . No more struggling ! Very easy to use . If you have a hot pipe with the external springs , this tool is for you !
$10.95

Deluxe T-bar with oiler

Speedmaster deluxe t-bar with oiler and valve
$49.95

Super Collet Removal Tool

Use this solid collet plug to remove your super collet without damage. Simply remove the existing insert, and loosen the screw 2-3 turns. Put this removal plug in place, and tighten the collet with two wrenches as you normally would. The collet pops off every time! No damage to the collet or insert. No holding the flywheel! Reusable many times.
$6.95

290/300 Rebuild Kit

All the basic parts to freshen up a Zenoah 290/300 PUM . Includes - piston ring / circlips / wrist pin / bearing set / seal set / gasket kit / o-ring set . This will get your 290/300 going strong again . Other parts are available .This kit only fits the 290/300.
$64.95 $57.00

260 Rebuild Kit

All the basic parts to freshen up a Zenoah 260 PUM . Includes - piston ring / circlips / wrist pin / bearing set / seal set / gasket kit / o-ring set . This will get your 260 going strong again . Other parts are available .This kit only fits the 260 .
$62.95 $55.00

O-ring Set - water jacket - 290/300

Large and small o-ring for the water jacket on Zenoah PUM's . This set fits the 290 / 300 only .
$3.75 $3.00

Bearing Set - complete

Crankshaft and wrist pin bearings sold as a set . Fits Zenoah 231/ 260 / 290 / 300 PUM
$25.95 $22.95