Filters
Close

260 Rebuild Kit

All the basic parts to freshen up a Zenoah 260 PUM . Includes - piston ring / circlips / wrist pin / bearing set / seal set / gasket kit / o-ring set . This will get your 260 going strong again . Other parts are available .This kit only fits the 260 .
Availability: In stock
Manufacturer part number: MRCM-260REBUILDKIT
Manufacturers: Zenoah , MRCM
Ship to
*
*
Shipping Method
Name
Estimated Delivery
Price
No shipping options
Old price: $62.95
$55.00
Write your own review
  • Only registered users can write reviews
*
*
  • Bad
  • Excellent
Customers who bought this item also bought

Carb Diaphragm

Genuine Walbro metering diaphragm
$4.95 $4.25

Carb Diaphram Gasket

Genuine Walbro carb diaphram gasket for WT series carbs . Will fit others .
$3.95 $2.50

Silica Gel Packets - (moisture indicating)-10PACK

Place these silica gel packets into the radio box to protect your radio gear and servos from moisture damage. These packets are reuseable .[Ultimate Moisture Absorption and Reactivation] Packet material is high quality coated paper for Ultimate Moisture Absorption and Heat Resistance for Reuse . Mixture of the highest performing white silica gel beads and few orange indicating beads; Orange beads will change to dark green when saturated with moisture; Easy to Read Orange means ready to use and Dark Green means replace or reactivate Packet material is semi-transparent, inner printed, and tear resistant with Ultimate Moisture Absorption; Packets are reusable via oven only (do not use microwave); Bake the packets at 150 to 200 F for 0.5 to 1.5 hours.Packet Specification (Packet dimension: 2 inch x 1.3 inch); 2 gram desiccant packets can cover approximately 240 cubic inch volume containers; We recommend placing more packets than recommended for extra protection. Sold as a packet of 10 !
$2.25

250ML Gas Bag

250ML Gas Bag
$8.50 $7.00

Water Jacket Installation Tool - V2.

By using this tool , the water jacket is pressed down over the o-rings to properly seat the water jacket .This tool threads into the sparkplug hole / tighten the jam nut to push the jacket down . Next install the 3mm bolts and tighten accordingly . This will lessen the possibility of stripping the small bolt holes . We have been using this style of tool for years . Very handy . Comes with bolt / jam nut / 2 steel washers / 1 nylon washer and a protective sleeve for storage .
$12.95 $8.95

Crankcase Bearing Alignment Tool

Precision ground shaft used for checking alignment of the crankshaft bearings when installed in the case . When used as a bearing installation tool , this tool ensures bearings go in straight and they are parallel to each other. If you have been pressing them in each half individually your bearings could possibly not be aligned to each other and can cause early bearing failure. Comes with protective end caps on the shaft .
$46.95