Flywheel Puller - V2

Version 2 flywheel puller . Handle & bolt equipped for easy use . Makes flywheel removal easy !
Availability: In stock
Manufacturer part number: MRCM - FLYPV2
Manufacturer: MRCM
Ship to
Shipping Method
Estimated Delivery
No shipping options
Write your own review
  • Only registered users can write reviews
  • Bad
  • Excellent
Customers who bought this item also bought

Flywheel Setting Tool Set

Tools used to properly seat & tighten a flywheel . The lever shaped tool threads into the flywheel to be used as a hand held device to keep the flywheel from turning . The included flanged nut is threaded onto the shaft in order to seat the flywheel correctly on the crankshaft stub. After tightening the flanged nut to seat the flywheel , untighten & remove the flanged nut . Remove the flywheel holder . Install & tighten the correct starter pawl .


Velcro strips

EZ Start Recoil Kit

easy start recoil kit

Zero Drag Seal Installation Tool

Zero Drag Seal Installation Tool

Driveshaft Alignment Tool

Alignment tool

Crankcase Bearing Alignment Tool

Precision ground shaft used for checking alignment of the crankshaft bearings when installed in the case . When used as a bearing installation tool , this tool ensures bearings go in straight and they are parallel to each other. If you have been pressing them in each half individually your bearings could possibly not be aligned to each other and can cause early bearing failure. Comes with protective end caps on the shaft .