Navigation

FREE SHIPPING ON MOST ORDERS OVER $100

SOME RESISTRICTIONS APPLY

UNITED STATES ONLY

MONTHLY DRAWING !!!!

Every purchase will include a ticket for our monthly drawing .

Each month starts new ticket numbers for the monthly drawing .

Many prize packages have already been claimed .

We have a winner !

This month's winner is

Jerry Payne

Warrior , Alabama

Cylinder Squish Indicator Tool

Availability: In stock
Manufacturer part number: ca970
Quick overview This tool is used for accurately measuring squish clearance. Compatible with all Zenoah /Quickdraw/ CY / RCMK RC engines. Also compatible with other engines that use a "vertical" 10mm spark plug. To get the most power from your engine the squish clearance should be set as accurate as possible without the piston hitting the top of the cylinder during operation. Use this tool to measure piston to head clearance. Comes with instructions.
$39.95
Write your own review
  • Only registered users can write reviews
*
*
Bad
Excellent
*
*
*
Additional information
Manufacturer: MRCM
Customers who bought this item also bought

Billet Carb Cover

Aluminum replacement cover for the carb diaphram
$15.95

Crankcase Bearing Alignment Tool

Precision ground shaft used for checking alignment of the crankshaft bearings when installed in the case . When used as a bearing installation tool , this tool ensures bearings go in straight and they are parallel to each other. If you have been pressing them in each half individually your bearings could possibly not be aligned to each other and can cause early bearing failure. Comes with protective end caps on the shaft .
$45.00

Water Jacket Installation Tool - V2.

By using this tool , the water jacket is pressed down over the o-rings to properly seat the water jacket .This tool threads into the sparkplug hole / tighten the jam nut to push the jacket down . Next install the 3mm bolts and tighten accordingly . This will lessen the possibility of stripping the small bolt holes . We have been using this style of tool for years . Very handy . Comes with bolt / jam nut / 2 steel washers / 1 nylon washer and a protective sleeve for storage .
$12.95 $8.95

Super Collet Removal Tool

Use this solid collet plug to remove your super collet without damage. Simply remove the existing insert, and loosen the screw 2-3 turns. Put this removal plug in place, and tighten the collet with two wrenches as you normally would. The collet pops off every time! No damage to the collet or insert. No holding the flywheel! Reusable many times.
$6.95

Aluminum isolator block - manifold

Aluminum isolator block with gaskets
$29.00

RCMK Flywheel Nut / Starter Pawl

New RCMK flywheel nut / starter pawl
$3.95 $1.00